PROAIM P-W5P24-BASE Assembly Manual page 7


Attach 3 hooks one after another to four wire tensioners.

Attach 2 hooks on both slots on cable guide. Then attach two extra hooks to hook attach to front side
and two hooks to hook attached on back side.
Cables Setup

Now attach one end of 2.2ft cable with Red Sleeves to hook on back side of cable guide and another
end to hook on 1st slot on jib section with the help of wire tensioner.

Attach 3.1ft cable with Red Sleeves to same hook on cable guide and another end with hook on 2nd
slot of rear section as shown below.
7