Advertisement
To prevent any harm or injury, properly join all sections of the crane. It is suggested to use the support
stand while telescoping the complete length.
Test operation before usage. Neglect of such a step can cause harm to equipment or operator.
Always connect the steel cables properly to provide stability to the system. They should not negatively
impact the movements of the crane in any way.
After setup of the crane, the pan-tilt head / gimbal head shall be positioned under the central pivot
section. In the assembled state, when the pan-tilt head / gimbal head is higher than the central pivot
section, there should be someone to look after the crane system.
The complete panning & lifting range around it must be kept free. Avoid anybody standing under the
crane. No loose objects may be stored or placed on it. Be very careful while using it indoors.
Never operate the crane near high-voltage power cables. It holds danger to life.
Particular care is required when operating the crane in unfavourable weather conditions. The crane
must be shut down in sufficient time. When it is used on a rainy day, the pan-tilt head / gimbal head and
controlling bar shall be protected against rain.
When you want to transport the crane, make sure that the components do not rub together and cause
any material wear.
Before the counterweights are removed, ensure the remote head is resting on the support stand. Then
gradually remove the counterweights before the remote head, camera or other parts.
In the interest of safe crane operation, avoid abruptly swivelling or stopping the crane; otherwise, it may
cause severe damage to equipment.
FOLLOWING THESE GUIDELINES WILL PROVIDE BETTER SHOTS AND TROUBLE-FREE OPERATION.
SHOULD YOU NEED ADDITIONAL INFORMATION, TECHNICAL ASSISTANCE IS AVAILABLE 'ONLINE' BY
CONTACTING THE SALES REPRESENTATIVE.
Dolly & Tripod Stand Setup
You will receive your D-37 dolly collapsed for shipping/storage purposes. To extend the legs, take out
the Allen bolts from both outer legs & pull out each leg until it reaches to joining connections and secure
with the bolts as shown below.
3
Advertisement
