Advertisement
To add stability to your Jib, attach wire tensioner with hook on Locking clamp, then attach one end of
safety chain with hook on D-37 dolly and attach other end with wire tensioner as shown below.
Wire tensioner and safety chain setup should be
properly aligned to ensure stability.
Jib Sections Setup
Install the 5th Section to the rear of vertical pivot point through bolt, washers and nut. Tighten the nut
properly to secure the section.
Slide in 6th section to the rear to join the 5th section. Install the Allen screws to the joining holes of
both the sections and tighten.
5
Advertisement
