Dataman S4 Manual page 70

DATAMAN S4 MANUAL
ESCape or ENTER leaves the rate set at the last
value shown.
On exit, you are prompted to change the terminal
baud rate.
EXECUTE
<R>
>>EXEC 01234
Starts program execution at the address requested.
This is mainly
for programmers who have written code for S4.
The default ADDRESS
is the last one used in the EDIT routine. You can
set any value you
please.
@BULLET = 00000 gives a cold start
@BULLET = 0F000 gives a warm
start<$&EXECUTE>
RS232
<$IRS232;Discussion>Serial
Interface<$&s4serial>
The serial RS232 interface uses an IC made by
Motorola, part number
MC145406, which meets RS232 standards of
voltage and current on inputs
and outputs.<MI>
<MI>Current can be sourced by the outputs into
any load on the RS232
interface, but it is unlikely that such current will
exceed 5ma. Nevertheless
this current comes from the battery. Leaving the
RS232 lead connected
will reduce battery life by about 20%. When S4
powers down, the RS232
70 EXECUTE