Dataman S4 Manual page 22

DATAMAN S4 MANUAL
@BULLET = The time taken to program the
PROM varies from a few seconds
to a few minutes.
@BULLET = 8. It is a wise precaution to take
the checkSUM of the master
PROM and the copies. CheckSUM will help you to
identify an unlabelled
PROM.
<$IDiagram, Block
Circuit><$IBIOS
Mode><$IKEY>PROM
KEY<$&PROM>
If you get a message on this key which says:
@COMPUTER TEXT = <R>
>>SELECT DEVICE<R>
NO LIBRARY LOADED<R>
>>
Then S4 will not program any PROM but 27256.
You should load the
library.
@COMPUTER TEXT = Fujitsu 2716<R>
25.00v TO PIN 21<R>
50ms SLOW<R>
Alg 02, Ref 0300
To configure S4 to read and program a PROM
correctly:
1. If you remember the Ref number of the
algorithm, enter it. The
number is shown when you scroll through the
ALGORITHMS as described
below. The Ref number is not guaranteed to be the
same in different
versions of the library.
22<$IDiagram, Block Circuit><$IBIOS Mode><$IKEY>PROM