DATAMAN S4 MANUAL
The Screen means the remote terminal screen.
The Display means either the terminal screen or
S4's liquid crystal.
The Keyboard refers to the remote terminal.
<$ILCD;Liquid Crystal Display>The LCD is S4's
own Liquid Crystal
Display. Outputs are shown boxed in the text,
meaning that this is
literally what you will see:
DATAMAN S4
512K BYTES RAM
NO LIBRARY LOADED
>
The Command Line means the display line which
starts with a prompt ">" An operation will be
performed if you press ENTER or
be aborted if you press ESCape.
ESCape Commands which are non-destructive (do
not change anything)
are actioned as soon as you press the key, without
waiting for ENTER
A Digit is always Hexadecimal - not Decimal.
An Address defines one location in memory
(expressed as 5 digits).
A Parameter is a set of Digits, two for a Byte, five
for an
Address.
<$IBlocks;Explanation>A Block means
contiguous bytes of memory from Start
address to End address inclusive. If three
parameters appear the
last is the Destination address.
10
Introduction to S4