Sega MARIO & SONIC AT THE RIO 2016 OLYMPIC GAMES Owner's Service Manual page 111

PROBLEM
With main switch ON there
is no activation
15
There is sound and lighting
but no video signal
No sound
Incorrect colour on
monitor
Screen saturation and
brightness not correct
Switch and volume pot
input does not work
Start button input does not
work
Lever button does not light Lamp failure
Stays on Nu1.1 logo and
does not go to advertise
screen (error)
Controller does not work
properly
Floor does not work
correctly
98
CAUSE
Power is not supplied
Supply voltage is not correct
Circuit protector activated
Video signal connector or
monitor power connector is
not properly connected
Volume not properly adjusted
Poor connection of
connectors
Board, amp or speaker fault
Poor connection of video
cable
Monitor fault
Screen not properly adjusted
Poor connection of
connectors
Switch fault
Poor condition of cabinet
Nu1.1 error
Improper controller
adjustment
Poor attachment of harness
Check connections within
harnessing.
Sensor failure
COUNTERMEASURE
Insert power lead all the way into
outlet
Make sure that supply voltage is
correct
Reset circuit protector/replace
fuse
Check connections of the monitor
and Nu 1.1 connector
Adjust volume
Check connections of Nu1.1 and
amp
Run speaker test to check.
Confirm connection of video/DVI
cable.
Contact point of purchase
Adjust screen settings
Check connection to I/O bd
Check the connection to Nu1.1
Replace switch
Replace lamp
Refer to list of errors
Contact point of purchase
Configure using TEST mode
Check harnessing to Controllers
Turn the power on/off and make
sure the initialization operation
completes successfully
Replace Jump or Foot sensor