Sega MARIO & SONIC AT THE RIO 2016 OLYMPIC GAMES Owner's Service Manual page 105

5
Once the Jump Sensor has been replaced please reassemble by following Steps 2 to 4 in reverse order.
6
Refer to Step 2 to remove the FLOOR PLATE SENSOR R.
7
Locate the corresponding Sensor (Sensor #6).
13
8
Remove the single fixing which secures the Jump Sensor to the Side Frame R.
11
9
Reassemble by following Steps 7 to 5 in reverse order.
92
Jump Sensor #6
Jump Sensor #6
370-5173-01
Lens Hole
SIDE FRAME R
Disconnect the connector
YL2P
Jump Sensor Plate Always align the lens of the Jump Sensor with
the Lens Hole.
When Changing Jump Sensors, it is advisable
to change both L & R sensors.
Lens
レンズ部
M3 × 12
Lens