Maintenance; Recommended Maintenance Schedule(S) - EGO Power+ ZT4200L Operator's Manual

MAINTENANCE

WARNING: Before performing any maintenance, stop the mower on a level surface and wait for the blades to come
to a complete stop. Set the parking brake and remove the safety key to avoid accidental starting and possible serious
personal injury.
WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could
result in objects being thrown into your eyes resulting in possible serious injury.
WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or
cause product damage. To ensure safety and reliability, all repairs should be performed by a qualified service technician.
WARNING: Strictly adhere to all torque wrench tightening specifica tions. Failure to do so could cause serious
personal injury.
NOTICE: Remain alert for unusual noises, as they could be signaling a problem. Visually inspect the product for any
abnormal wear or damage. Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc, along with wire and string tangles. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced.

RECOMMENDED MAINTENANCE SCHEDULE(S)

Maintenance Service Interval
Before each use or daily
After each use
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Before storage
Annually
◾
Check the safety-interlock system.
◾
Visually check the tire whether it is flat.
◾
Inspect the blades.
◾
Inspect the entire product for damaged, missing, or loose parts such as side-
discharge chute, screws, nuts, bolts, caps, etc., ensuring that all gurads are in
place and working properly.
◾
Clean the mower deck.
◾
Check tire pressure.
◾
Check the grease condition inside the cutting blade flange.
◾
Check the rear wheels, ensuring that the 4 lug nuts are fastened at the
recommended torque.
◾
Check the front wheels, ensuring that they turn freely.
◾
Remove the batteries from the mower.
◾
Remove the safety key from the mower.
◾
Perform all maintenance procedures listed above and thoroughly clean the
mower.
◾
Inspect the entire product for damaged, missing, or loose parts, replace or
tighten the corresponding ones before storage.
◾
Check the parking brake pedal. Remove the battery from the mower and set
the parking pedal at the braking position. Manually push the mower forwards
to see whether the mower can be moved or not. If it moves, have it serviced
by a qualified service technician.
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200L/ZT4200L-FC
Maintenance Procedure
43