To Play Sequences; Edit And View The Notes And Pad Triggers In A Sequence - 1010music Blackbox User Manual

into the currently selected sequence. Only the notes you play on PADS or KEYS will be added to the sequence.
You can push REC while another sequence is playing to start recording immediately into the selected sequence.
•

To Play Sequences:

1. Push SEQS to see the sequences grid.
2. Touch sequence cells to toggle their active state. Active sequences have a white frame. You can play multiple
sequences at once.
3. Push PLAY to start playing the active sequences.
4. Touch sequence cells to turn them on or off. The cells start and stop in alignment with the sequence's quantization
settings. A blue progress bar shows the current playback state of the sequence. A white progress bar indicates that
the sequence will start at the next quantization break.
5. Push STOP when you are finished. If some WAV files remain playing, you can push STOP again to turn them off.
Note:
Some sequences trigger long WAV files. These WAV files may still be playing after the sequence stops.
•
Some sequences use toggle mode to trigger WAV files. It's possible to stop a sequence between the toggle on and
•
the toggle off notes, leaving the WAV still playing after the sequence stops.
You can record a sequence while others are playing. Simply push REC in this case to start and stop recording. You
•
can even switch which sequence you are recording into without pushing STOP.
To Edit and View the Notes and Pad Triggers in a Sequence:
You can use the INFO button with a selected sequence cell to view and edit the sequence.
1. Touch a sequence cell to select it.
2. Push the INFO button to drill into that cell. Blackbox will display the sequence
editor screen. If you recorded the sequence using KEYS, the piano roll view will
have a keyboard representing the scale along the left side of the screen. In Pads
Mode, the left edge lists the pad numbers. The piano roll displays the notes or pads
recorded for each step over time moving from left to right. You can touch the view
mode button at the top of the screen to switch view modes between KEYS and
PADS.
3. If you recorded Keys input for more than one pad, you can select the pad to view
and edit in the piano roll by touching the grid icon in the top right in KEYS view, then
touching the cell for the desired pad.
4. You can use the control knobs and touch gestures to adjust notes and to zoom and
scroll through the sequencer:
Action
Turn the top left control knob
Turn the top right control knob
Turn the bottom left control knob
4/10/19 6:08 PM
Page 27 of 49
BLACKBOX USER MANUAL v 0.9.8
Result
Cycles the note selection through the notes on the
piano roll
Change the length of the currently selected note
Moves the position of the step cursor
Copyright 1010music LLC 2019
P iano R oll Key s View
P iano R oll Pa d Selec to r