Installation; Pre-Installation Instructions; Installation Procedure - Mitsubishi Electric 800 Series Instruction Manual

2

INSTALLATION

2.1

Pre-installation instructions

Check that the inverter's input power and the control circuit power are both OFF.
Caution
 With input power ON, do not install or remove the product. Otherwise, the inverter and the product may be damaged.
 To avoid damage due to static electricity, static electricity in your body must be discharged before you touch the product.
2.2

Installation procedure

(1) Remove the Ethernet board from the inverter. (Refer to the Instruction Manual of the inverter.)
(2) For the two mounting holes that will not be tightened with mounting screws, insert spacers.
(3) Fit the connector of the product to the guide of the connector on the inverter unit side, and insert the product as far as it
goes. (Install the product to the connector used for the Ethernet board.)
(4) Fit the two locations on the left and right of the product securely to the inverter by screwing in the mounting screws
supplied with the product. (tightening torque 0.33 N·m to 0.40 N·m) If the screw holes do not line up, the connector may not
be inserted deep enough. Check the connector.
10
INSTALLATION