Mitsubishi Electric 800 Series Instruction Manual page 93

• When "11 or 13" is set in Pr.999, the communication parameters for the GOT connection via RS-485 terminals are
automatically set.
Pr.
79 Operation mode selection
332 RS-485 communication speed
333 RS-485 communication stop bit length / data length
334 RS-485 communication parity check selection
335 RS-485 communication retry count
336 RS-485 communication check time interval
337 RS-485 communication waiting time setting
340 Communication startup mode selection
341 RS-485 communication CR/LF selection
414 PLC function operation selection
549 Protocol selection

When Pr.414 ="1", the setting value is not changed.

Refer to the Instruction Manual (Detailed) of the inverter.
• Initial setting with the GOT2000 series
- When "FREQROL 500/700/800, SENSORLESS SERVO" is selected for "Controller Type" in the GOT setting, set Pr.999 ="11" to configure
the GOT initial setting.
- When "FREQROL 800 (Automatic Negotiation)" is selected for "Controller Type" in the GOT setting, the GOT automatic connection can be
used. When "FREQROL 800(Automatic Negotiation)" is selected for "Controller Type" in the GOT setting and the GOT automatic
connection is not used, set Pr.999 ="13" to configure the GOT initial setting. (Refer to
• Initial setting with the GOT1000 series
- Set Pr.999 ="11" to configure the GOT initial setting.
NOTE
• Always perform an inverter reset after the initial setting.
• For the details of connection with GOT, refer to the Instruction Manual of GOT.
• For the details of other Pr.999 settings, refer to the Instruction Manual (Detailed) of the inverter.
92
PARAMETER
Name Initial value Pr.999 ="11"
0 0
96 192
1 10
2 1
1 9999
0 s 9999
9999 0 ms
0 1
1 1
0 ─
0 0
page 88)
Refer to
Pr.999 ="13"
page
0 16
1152
0
1
32
9999
9999
0 ms
1

1 32
2
 
0 59