Panasonic HL-C1 Series User Manual page 55

CHAPTER 4 MEASUREMENT
4-2 Measuring Height
This section explains measurement of differences in height of a measured object for a
reference surface. Basic operation is explained measuring the surface of a plate used as an
example.
Procedure
1. Check all connections.
Confirm that the controller, sensor head, and compact console are connected.
2. Turn on power.
When the controller and sensor head have completed automatic start-up, the laser
emission indicator (green) lights and the laser radiates. If the measurement object is within
the measurement range, a measurement value is displayed on the compact console.
3. Adjust the position of the sensor head.
Set the orientation of the measurement object
and the sensor head referencing "Mounting
the Sensor Head" on page 2-4.
While observing the measurement range
indicator (yellow) of the sensor head or
measurement
console, adjust the mounting position of the
sensor head so the approximate measure-
ment center is in the center of the measure-
ment object variation range.
The measurement range indicator (yellow)
blinks when the distance from the measure-
ment object is within the measurement range
and remains lit when near the measurement
center distance.
display on the
Measurement Waveform
Measurement
Range Indicator
compact
4-5
Laser Emission
Indicator
Measurement
center distance