Panasonic HL-C1 Series User Manual page 159

CHAPTER 9 SPECIFICATIONS
9-2 Controller
Model No.
Supply voltage
Current consumption
Sampling period
Serial input/output
Thermal characteristics
Voltage
Analog
Output
Current (*1)
Alarm Output
Output Operation
Short Circuit Protection
Judgment Output
(O , O )
1 2
Output Operation
Short Circuit Protection
Timing Input
(Laser emission)
Zero Set ON Input
Zero Set OFF Input
NPN Output
HL-C1C
24V DC ±10% Incl. ripple 0.5V (P-P)
When 2 sensors are connected: Approx. 550mA
When 1 sensor is connected: Approx. 430mA
100µs, 144µs, 200µs, 255µs, 332µs, 498µs, 1,000µs
Output voltage: –5 to +5V/F.S. (diffused reflection mode)
–4 to +4V/F.S. (specular reflection mode)
(Variable by analog output setting maximum value at power ON: ±5V)
Output range: –10.9 to +10.9V, max. 2mA, output impedance 50
Output voltage: 4 to 20mA/F.S. (diffused reflection mode)
5.6 to 18.4mA/F.S. (specular reflection mode)
(Variable by analog output setting Maximum value at power ON: +20mA)
Output range: 0 to 29.5mA (Max. 25mA at max. load impedance)
Load impedance: 250 max.
N-channel FET Open Drain
Maximum in-flow current: 100mA
Applied Voltage: 30V DC or less
(While alarm output is 0V)
ON impedance: 5  or less
ON when the amount of light is excessive or insufficient.
N-channel FET Open Drain
Maximum in-flow current: 100mA
Applied Voltage: 30V DC or less
(While judgment output is 0V)
ON impedance: 5 or less
Opened or closed when the threshold value is reached. Determined
based on judgment output mode selection.
(The threshold value varies with the hysteresis setting.)
Laser emission stops or continues
if a short or open circuit occurs:
Determined based on input mode
selection.
Zero set goes ON when there is a
short circuit.
Zero set goes OFF when there is a
short circuit.
RS-232C
o
±0.01% F.S./ C
Photo-MOS
Maximum load current: 50mA
Applied Voltage: 30V DC or less
(While alarm output is COM)
ON impedance: 35  or less
Operation time: max. 2ms
Incorporated
Photo-MOS
Maximum load current: 50mA
Applied Voltage: 30V DC or less
(While judgment output is COM)
ON impedance: 35  or less
Operation time: max. 2ms
Incorporated
Working input voltage : 12 to 24V DC
Maximum input voltage : 30V DC
Laser emission stops or continues
when voltage is input or there is an
open circuit:
Determined based on input mode
selection.
Working input voltage : 12 to 24V DC
Maximum input voltage : 30V DC
Zero-set: ON when voltage is input
Working input voltage : 12 to 24V DC
Maximum input voltage : 30V DC
Zero set: OFF when voltage is input
9-3
Photo-MOS output
HL-C1C-M