Panasonic HL-C1 Series User Manual page 42

Wiring
1. Strip insulation from
the end of the wire.
Use the device as directed.
• Turn power supply off before wiring and remove or install the terminal block.
• Do not use wires tinned with solder. They may break when subjected to vibration.
• Wiring to the terminal block must not exceed 30m.
CHAPTER 3 INPUT AND OUTPUT TERMINAL BLOCKS
2. Insert the wire in the
terminal block until it
contacts the back, then
secure it by tightening
the screw.
3-2
3. If more than 1 wire is
inserted into the same
terminal, twist
before inserting them.
wires