Remote Control - M Design True Vision Series Instructions For Installation And Use Manual

12. Remote control (direct ingnition)
1. First use (Connect the remote control)
1
2. Ignite the fire
3. Manual control
Keep pressing the button
until 24:00 appears in the top left
corner (1).
Press several times on
until you see "bnd" on the screen (2)
Press shortly on
You see the temperature on the
screen. Your remote control is now
connected.
2
Press simultaneously
on and
You hear the ionisationpen ticking.
The ticking lasts for about 15 sec.
At initial setup, it's possible that the pilot flame
doesn't ignite imidiatly because the pipes are not
yet fully deflated. You can try this up to 5 times
before the unit will be placed in safety. If this fails,
pleas contact your installer.
From the moment the burner 1 is on, you can
start with the flame height control.
The screen will automatically show manual
control ( flame heigt control )
Press on
This is the maximum flame height.
Choose a flame height from 1 to 15
by pressing
2
2
Instructions for installation and use TRUE VISION Gas
and
until you see number 15.
or
2
2
2
1
28