Advertisement
R8200 Series with Simpli™ Roseless Trim
Mortise Lock
Installation Instructions
8
How to Change Hand of Lockbody
NOTE: Red surface of locking piece must face
secure (keyed/locked) side of door.
To rotate locking piece:
1. Position lockbody with red surface of locking
piece visible. (Figure 12)
2. Insert blade type screwdriver into locking piece
slot to rotate locking piece.
3. Push locking piece toward back of lockbody
and rotate 180° until RED surface shows on
opposite side.
IMPORTANT:
04, 06, 13 and 31 functions require:
1. Remove green catch screw.
2. Rotate hub 45° to vertical position.
3. Rotate locking piece for required hand.
NOTE: Red surface faces locked side of door.
4. Rotate hub to original 45° position as shown
on lock case.
5. Reinstall green catch screw.
NOTE: Beveled surface of latch must face strike.
Deadlatch is self adjusting.
To change hand of latch:
1. Insert flat blade screwdriver into spade shaped
slot. (Figure 13)
2. Rotate screwdriver 90º to push latch out until
back of latch clears lock front.
3. Rotate latch 180º. Latch will re-enter lockbody.
(Figure 14)
NOTE: Latch cannot be unscrewed.
1-800-727-5477 • www.sargentlock.com
Copyright © 2010, 2020, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole
or in part without the express written permission of SARGENT Manufacturing Company is prohibited.
Locking Piece Slot
Figure 12 Pxxx
Spade Shaped Slot
Figure 13 Pxxx
Lockbody Front
Latch
Figure 14 Pxxx
7
RED Surface
A8030D 02/20
Advertisement
