Advertisement
R8200 Series with Simpli™ Roseless Trim
Mortise Lock
Installation Instructions
2
Install Lockbody, Outside Lever Assembly and Spindle
IMPORTANT:
Check template A4647 to prep door for
function holes, size and location. Verify
strike location according to template.
Clean out door pocket and door edge of
any debris. Make sure handing of lock
(latch and locking piece) match handing
of door.
NOTE: Keep door open during installation.
1. Slide lockbody into door. (Figure 2)
2. Slide outside lever assembly through
door and lockbody and hold.
(Figure 2)
3. Insert spindle into lockbody hub.
(Figure 3)
3
Install Inside Adapter and Cylinder
1. Slide inside adapter over spindle. Verify
threaded hole in adapter faces hinge.
(Figure 4)
2. Sliding cylinder through spring and
collar, thread into lockbody until flush
with collar. Verify logo is straight and at
top. (Figure 5)
3. Secure cylinder in lockbody using
access hole just above deadbolt
opening. (Figure 6)
1-800-727-5477 • www.sargentlock.com
Copyright © 2010, 2020, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole
or in part without the express written permission of SARGENT Manufacturing Company is prohibited.
Inside of
Door
Outside of
Door
RHR Door Shown
Figure 2 Parts
Threaded Hole
Latchbolt
Figure 4 Pxxx
Outside of
Door
Figure 5 Pxxx
3
Inside of
Door
Spindle
Figure 3 Pxxx
Inside of
Door
Outside of
Door
Figure 6 Pxxx
A8030D 02/20
Advertisement
