Victron energy Color Control GX Manual page 38

Last update: 2020-08-19 12:10
it is in:
#1: Low SOC: discharge disabled
#2: BatteryLife is active
#3: Charging disabled by BMS
#4: Discharging disabled by BMS
#5: Slow Charge in progress (part of BatteryLife, see above)
#6: User configured a charge limit of zero.
#7: User configured a discharge limit of zero.
5. VRM Portal
5.1 VRM Portal Introduction
When connected to the internet, a GX device can be used in combination with the
Management (VRM) portal, which enables:
Easy remote access to all statistics and systems status online
Remote Console on VRM: access and configure your system as if you were standing besides it
Remote Firmware updates of connected Solar Chargers and other Victron products.
Use of the VRM App for iOS and
See chapter 1 for how to connect the device to the internet.
5.2 Registering on VRM
Instructions are in the
Note that any system will need to first have been able to successfully send data to the VRM Portal. As
long is there has been no successful connection, it will not be possible to register the system to your
VRM user account. In such case, refer to below Troubleshooting section 5.7.
5.3 Datalogging to VRM
Data-logs are transmitted to the VRM Portal over the Internet, if it's available. All related settings are
available in the VRM Online Portal menu:
https://www.victronenergy.com/live/
Android.
VRM Portal Getting Started
ccgx:start https://www.victronenergy.com/live/ccgx:start?rev=1597831811
document.
Victron Remote
Printed on 2020-11-10 02:37