Air Filter: Clean Housing And Renew Filter Element - Volkswagen Amarok 2011 Service & Maintenance

Amarok 2011 ➤
Maintenance - Edition 10.2012
Recommended coolant level at delivery inspection:
♦ Coolant level above "Min. marking" -arrow-.
Recommended coolant level at inspection service
• Slightly above area -arrow-.
– If coolant is too low, add required amount according to mixture
ratio.
Note
If fluid loss is greater than can be expected through normal use,
determine source and rectify (repair measure).
5.26.4 Mixture ratio
Frost protection to
-25 °C
-35 °C
-40 °C
Note
Coolant additive G 12 Plus Plus prevents frost and corrosion
♦
damage, scaling and also raises boiling point of coolant. For
these reasons, the cooling system must be filled all-year-
round with a coolant and corrosion protection additives.
Because of its high boiling point, the coolant improves engine
♦
reliability under heavy loads, particularly in countries with trop‐
ical climates.
The coolant concentration must not be reduced by adding wa‐
♦
ter even in warmer seasons and in warmer countries. The
antifreeze portion must be at least 40 %.
5.27 Air filter: Clean housing and renew filter
element
Note
When replacing air filter, make sure that no dirt gets into intake
♦
hose, air mass meter -G70- and air filter cover.
Following each air filter change, programmed values of engine
♦
control unit -J623- must be reset using Guided fault finding
with vehicle diagnostic, testing and information system -VAS
5051B- or vehicle diagnostic and service information system
-VAS 5052 A- ⇒ page 121
Note
In dusty countries, new dust and pollen filter must be fitted as
separate job ⇒ page 110
Special tools and workshop equipment required
118
5. Descriptions of work
Coolant additive G 12 Plus Plus
approx. 40 %
approx. 50 %
approx. 60 %
.
.
Water
approx. 60 %
approx. 50 %
approx. 40 %