5.47.2
Oil at operating temperature
Test prerequisites
•
Engine switched off
Perform the following jobs:
– Unscrew sealing cover -arrow- with built-in dipstick from tank.
– Wipe off dipstick using a clean cloth.
– Screw sealing cover on until finger tight and then unscrew
again, after which fluid level can be checked.
The oil level must be in the area of the "80°C" mark.
Note
If the fluid level is above the area specified, the excessive fluid
♦
must be extracted.
If the oil level is below the area specified, the hydraulic system
♦
must be checked for leaks (repair measure) and, if necessary,
topped up with hydraulic oil -G 002 000- .
– Screw sealing cover onto tank until finger tight.
5.48
Doors: Grease door arrester
Perform the following jobs:
– Lubricate door arrester at positions marked -arrows-.
– Use lubricating paste -G 000 150- or lock cylinder lubricating
spray -G 052 778 A2- .
5.49
Paint: Perform visual check for damage
and corrosion, interior and exterior when
doors and bonnet/rear lid/flaps are open
Perform the following jobs:
– Visual check on paint for damage and corrosion, interior and
exterior when bonnet/rear lid/doors and flaps are open.
– After the visual check, tick the corresponding field in the serv‐
ice record.
If damage is determined during visual check, make entries in the
service schedule:
– Put a cross in "Repair recommendation" on "Service record"
page in service schedule.
– Additionally describe exactly what part of vehicle is affected or
damaged etc. in field "Notes" below "Workshop comments" in
the service schedule.
Amarok 2011 ➤
Maintenance - Edition 10.2012
5. Descriptions of work
145