2.7.3
Cleaning work on the clutch
Note
Clean splines of drive shaft and, if the clutch plate has been used,
clean the splines of the hub. Remove corrosion and apply a very
thin layer of lubricating grease for male splines of clutch plates -
G 000 100- to the splines. Then, move the clutch plate back and
forth on the drive shaft until the hub moves easily on the shaft.
Remove excess grease.
– In order to reduce the smell of a burned clutch, the clutch
housing as well as the stopping face of the flywheel must be
thoroughly cleaned with a cloth.
2.7.4
Cleaning work on bolts and nuts
Note
Residual locking agent must be removed from all threaded holes
into which self-locking bolts are screwed; this is done with a screw
tap. Otherwise, there is a danger that the bolts will shear off when
refitted.
Amarok 2011 ➤
Maintenance - Edition 10.2012
2. General rules of cleanliness
37