Volkswagen Amarok 2011 Service & Maintenance page 91

– Remove cable tie by unscrewing it from stud.
Procedure for all vehicles
Perform the following jobs:
– Remove battery cut-off relay with electrical wiring harness
and, if necessary, adapter cable for RHD.
– Unscrew jump start point (17 mm) -1- from battery positive
terminal and remove.
– Route cable to main fuse box -2- to battery positive terminal.
– Place the cable in the envisaged position -arrow- in the termi‐
nal protector on the battery positive terminal.
– Now secure cable to main fuse box -2- with jump start point
-1- to battery positive terminal.
Specified torque: 8 ± 1 Nm
– Remove red terminal cap -1- from ashtray and insert it into
thread of jump start point -2-.
– Reconnect battery terminal clamp to battery negative terminal.
– Tighten securing bolt of terminal clamp to specified torque
⇒ page 83 .
– Install battery cover.
Note
If the battery has been reconnected, observe procedures descri‐
bed in ⇒ Electrical system; Rep. gr. 27 .
Amarok 2011 ➤
Maintenance - Edition 10.2012
5. Descriptions of work
87