Volkswagen Amarok 2011 Service & Maintenance page 160

Amarok 2011 ➤
Maintenance - Edition 10.2012
– Enter displayed values on EET data sheet under "Test values
for exhaust emissions test" on display in following sequence:
1 - Test speed (idling speed)
2 - Warm-up phase for catalytic converter
3 - Engine temperature
4 - Increased idling speed
5 - CO content at increased idling speed
6 - Lambda at increased idling speed
7 - Idling speed
8 - Select regulating probe type, either "step-type probe", or
"broad-band probe" -item 1-.
9 - Lambda probe value
– When all data have been entered properly, press
button -arrow-.
Specified data input for EET as bar code:
– If EET nominal data is present in bar code format then read in
bar code of EET data sheet using reader pen.
All data required are shown on display.
– Press -button- to continue procedure.
►
Visual check
– Follow instructions on display.
– Perform visual checks.
– If visual check is OK press
Note
When button is pressed a check will be carried out.
not OK
The visual check is displayed with the request to connect the di‐
agnosis connector -arrow A- and to check the MI lamp
-arrow B-.
– Follow instructions on display.
– Switch off ignition.
156
6. Exhaust emissions test
Continue
button. Press -arrow-.
OK