4 Assembly and pre-installation
4.5 Basic sequence for installation
Tools required
Phillips screwdriver
■
Slotted screwdriver 0.6 x 3.5 and 0.4 x 2.5
■
Socket spanner, sizes 7, 8, 5.5
■
No. 4 Allen key
■
Requirements
Check that the following requirements have been met:
The technical requirements for the combi oven are fulfilled, see 'Requirements relating to the con‐
■
figuration of the combi oven' on page 34
The combi oven is disconnected from the power supply and secured against the power being
■
switched on again.
Make sure that the appliance is de-energized.
■
The combi oven is set up so that it cannot tip over or slide, possible with a supporting structure
■
(worktable, oven stand or stacking kit).
The installation kit components have been removed from the packaging and the contents checked
■
to ensure that all parts are present.
There are two people or suitable equipment available for lifting the hood.
■
Installation procedure
Step
Action
Connect the control cable to the appliance.
1
Glue the fixing element at the back to the
2
top box of the appliance.
Install the hood on the appliance.
3
Connect the hood.
4
Install the hood front.
5
Fit the baffle filter.
6
Operating and installation instructions
See
'Connecting the control cable to the appli‐
ance' on page 37
'Attaching the rear adhesive fixing element'
on page 40
'Fitting the hood' on page 41
'Connecting the hood' on page 43
'Fitting the hood front' on page 44
'Fitting the baffle filter' on page 45
36