Table of Contents
Advertisement
General Description of Functions
If settings are changed, undefined states of the system may occur for a short time (for approx. 50 ms).
5.3.2 Manual Operating Mode
WARNING
Through an external signal, manual operation is exited, external signals are evalu-
ated and system parts move.
Personal injury or damage to property due to collisions
4 Ensure that the danger zone of the system is clear of people during operation.
4 Wear the required personal protective equipment (PPE) when working in the danger
zone.
WARNING
Falling objects due to incorrect operation in manual mode
Risk of injury
4 Higher level of attention
4 Ensure that there are no persons within the danger zones of the machine/system
In manual mode, a higher level of attention is advisable because incorrect operation may cause gripped
parts to fall, resulting in injuries.
In manual mode, the "suction" and "blow off" ejector functions can be controlled independently of the
higher-level controller using the buttons on the operating panel. In this operating mode, the "H1" and
"H2" LEDs both flash.
Because the valve protection function is deactivated in manual mode, this function can be used to locate
and rectify leaks in the vacuum circuit.
Activating the Operating Mode
Press and hold the
Manual suction
The
button activates "suction" on the ejector.
Press the
or
button to exit the "suction" operating state again.
When the air saving function is switched on, it is also active in the "Manual Operation" operating mode.
Manual blow off
The
button activates "blow off" on the ejector for as long as the button is pressed. The H1 and H2
LEDs light up simultaneously.
Deactivating the Operating Mode
Using the
button or through an external state change by signal inputs.
The valve protection function is not active in manual mode.
16 / 40
or
button for more than 3 seconds.
EN-US · 30.30.01.02636 · 00 · 01/21
Advertisement
Table of Contents
