How To Use Factory Mode - NEC MultiSync 20WGX2 Series Service Manual

3.3 Enter Burn-in Mode
a) No signal input.
b) Press "RESET" + "SELECT" button then into Burn-in mode.

3.4 How to use Factory Mode

Page 1
■ HOURS RUNNING
Indicate the "monitor power ON time" and "power save time" counted from factory shipment.
Hours Running function has four kinds of timer.
a. Monitor power on time (Reset-able)
b. Power save time (Reset-able)
c. Monitor power on time (Un reset-able)
d. Power save time (Un reset-able)
Note1: Power save time = Stand by mode + Suspend mode + off mode
(Do not include complete off mode.)
The default is Reset-able timers, so reset-able timers shall be shown when open the tag which includes
Hours Running function.
Indication of Reset-able and Un reset-able can be changed by key input.
"RESET" + "LEFT": Display Reset-able timers
"RESET" + "RIGHT": Display Un reset-able timers
When "RESET" + "LEFT" + "SELECT" key is pressed during displaying Reset-able or Un reset-able
timers, reset the Reset-able timers to "0" and display Reset-able timers.
The Reset-able timers are reset to "0" by "Factory Preset" in factory mode.
All timers shall be counted up every 5 minutes and count up to 65535H55M after that all timers keep
65535H55M. Do not reset to 00000H00M after 65535H55M.
RESET + SELECT
4- 5