Table of Contents
Advertisement
Installation Instructions
Warning
Warning
18
Connecting devices
The power supply plug must be withdrawn!
Please read the documentation for the external devices prior to connecting
them.
During thunderstorms, plug connector must neither be inserted nor
removed.
When disconnecting a plug connector, always handle it at the plug. Do not
pull the cable!
Connecting cables
The connections are located at the side of the Industrial PC and at the rear
(power supply connection), and are documented in the section where the
product is described.
When connecting the cables to the Industrial PC, proceed according to the
following sequence:
•
Switch off all the devices that are to be connected.
•
Disconnect all the devices that are to be connected from the power
supply.
•
Connect all the cables between the Industrial PC and to the
devices that are to be connected.
•
Connect all data transfer cables (if present) to the appropriate
plug-in receptacles of the data/telecommunication networks.
•
Reconnect all devices to the power supply.
Check voltage rating and connect
With compact 100-240 V
1. Check that the mains voltage is correct.
2. Insert the power supply cable that you have assembled (see the
section on
Fitting the Power Supply
power supply socket. Then connect it to a power socket with a
grounded earth connection.
When fitted with the (optional) 24 V
1. Check that the external power supply is providing the correct
voltage.
2. Insert the power supply cable that you have assembled (see the
section on
Fitting the Power Supply
power supply socket. Then connect it to your external 24 V power
supply.
If a 24 V UPS is installed, the correct type of rechargeable battery
must be used.
50/60 Hz power supply:
AC
Cable) into the Industrial PC's
power supply unit:
DC
Cable) into the Industrial PC's
C33xx
Advertisement
Table of Contents
