Set The Network Address - Allen-Bradley Rockwell Automation 1734-AENT User Manual

Set the Network Address

The new configuration is:
A
128.1.0.1
Network 1
B
128.2.64.1
128.2.64.2
Network 2.1
D
128.2.128.1
Network 2.2
A second network with Hosts D and E was added. Gateway G2 connects
Network 2.1 with Network 2.2.
Hosts D and E will use Gateway G2 to communicate with hosts not on
Network 2.2.
Hosts B and C will use Gateway G to communicate with hosts not on
Network 2.1.
When B is communicating with D, G (the configured Gateway for B) will
route the data from B to D through G2.
The adapter ships with the thumbwheel switches set to 999 and DHCP
enabled. You can set the network Internet Protocol (IP) address in these ways:
• Use the thumbwheel switches located on the module.
• Use a Dynamic Host Configuration Protocol (DHCP) server, such as
Rockwell Automation BootP/DHCP.
• Retrieve the IP address from nonvolatile memory.
Network address
thumbwheel
Press either the + or -
buttons to change the
number.
Configure the Adapter for Your EtherNet/IP Network
128.1.0.2
G
128.2.64.3
G2
128.2.128.2
128.2.128.3
Publication 1734-UM011D-EN-P - May 2011
19
43248