Mount The Adapter On A Din Rail Before Installing Modules - Allen-Bradley Rockwell Automation 1734-AENT User Manual

10 Install the Adapter
Mount the Adapter on a DIN
Rail Before Installing
Modules
Publication 1734-UM011D-EN-P - May 2011
Use the following procedure to mount the adapter on a new system before you
install any I/O modules.
1. Position the adapter vertically above the DIN rail.
2. Press down firmly to install the adapter on the DIN rail, noting that the
locking mechanism locks the adapter to the DIN rail.
3. Set the network address thumbwheel switches to the desired value. For
more information, see Set the Network Address on page 19.
If you connect or disconnect the Ethernet cable with power
WARNING
applied to this module or any device on the network, an
electrical arc can occur. This could cause an explosion in
hazardous location installations.
Be sure that power is removed or the area is nonhazardous
before proceeding.
4. Slide the safety end cap up to remove it.
This exposes the backplane and power interconnections.
Do not discard the adapter's end cap. Use this end cap to cover
ATTENTION
the exposed interconnections on the last mounting base on the
DIN rail. Failure to do so could result in equipment damage or
injury from electric shock.
43520