Storing The Vehicle - Jeep Gladiator 2021 Owner's Manual

WARNING!
The temperature grade for this tire is estab-
lished for a tire that is properly inflated and
not overloaded. Excessive speed, under-infla-
tion, or excessive loading, either separately or
in combination, can cause heat build-up and
possible tire failure.

STORING THE VEHICLE

WARNING!
Take care to avoid the radiator cooling fan

whenever the hood is raised. It can start
anytime the ignition switch is ON. You can
be injured by moving fan blades.
Remove any metal jewelry such as rings,

watch bands and bracelets that could
make an inadvertent electrical contact. You
could be seriously injured.
Vehicles with the Stop/Start system will be

equipped with two batteries. Both the main
and the supplemental batteries must be
disconnected to completely de-energize the
12 Volt electrical system.
WARNING! (Continued)
Serious injury or death could result if you do

not disconnect both batteries. To learn how
to properly disconnect, see an authorized
dealer.
If the negative battery cables are not isolated
properly it can cause a potential power spike
or surge in the system, resulting in damage to
essential electrical components.
If you are storing your vehicle for more than
3 weeks, we recommend that you take the
following steps to minimize the drain on your
vehicle's battery:
Disconnect the negative cable from the

battery.
If your vehicle is equipped with Stop/Start

system then disconnect both the main and
supplemental negative battery cables.
Any time you store your vehicle or keep it out

of service (i.e., vacation) for two weeks or
(Continued)
more, run the air conditioning system at idle
for about five minutes in the fresh air and
CAUTION!
SERVICING AND MAINTENANCE
high blower setting. This will ensure
adequate system lubrication to minimize the
possibility of compressor damage when the
system is started again.
If assistance is needed to disconnect the

battery system, see an authorized dealer.
Battery Cable Disconnect
1 — Supplemental Negative Battery Cable
2 — Main Negative Battery Cable
3 — Intelligent Battery Sensor (IBS)
4 — Main Negative Battery Terminal
NOTE:
You must isolate the supplemental battery

connection point, as well as the main battery
terminal from the post, as shown in the
443
8