Jeep Gladiator 2021 Owner's Manual page 427

2. Turn the socket assembly a quarter turn
counterclockwise and remove from
housing. Pull the bulb straight from the
socket to replace.
LED Front Side Marker
See below steps to replace:
1. Remove the front wheel liner fasteners to
access side maker screw and electrical
connector.
2. Remove fastening screw in the back of the
front side maker assembly and disconnect
electrical connector.
3. Remove and replace LED front side marker
light assembly.
Front Fog Lamp
NOTE:
We advise seeing an authorized dealer for
service on LED and Halogen front fog lamps.
See below steps to replace:
1. Reach under the vehicle to access the
back of the front fog lamp.
2. Disconnect the wire harness connector
from the front fog lamp connector
receptacle.
3. Firmly grab the bulb by the two latch
features and squeeze them together to
unlock the bulb from the back of the front
fog lamp housing.
4. Pull the bulb straight out from the keyed
opening in the housing and then connect
the replacement bulb.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps
they are replaced as an assembly.
SERVICING AND MAINTENANCE
Rear Tail, Stop, Turn Signal, And Backup Lamp
See below steps to replace:
1. Remove the two screws that pass through
the bed sheet metal.
Tail Lamp Screws
2. Pull the outboard side of the lamp rearward,
far enough to unsnap the two receptacles
on the outboard side of the lamp housing,
from the two plastic snap post retainers in
the outer box side panel.
425
8