Refueling In Emergency - If Equipped - Jeep Gladiator 2021 Owner's Manual

CAUTION!
Do not run the booster vehicle engine above
2,000 RPM since it provides no charging ben-
efit, wastes fuel, and can damage booster
vehicle engine.
6. Once the engine is started, follow the
disconnecting procedure below.
Disconnecting The Jumper Cables
1. Disconnect the negative (-) end of the
jumper cable from the engine ground of
the vehicle with the discharged battery.
2. Disconnect the opposite end of the negative
(-) jumper cable from the negative (-) post of
the booster battery.
3. Disconnect the positive (+) end of the
jumper cable from the positive (+) post of
the booster battery.
4. Disconnect the opposite end of the positive
(+) jumper cable from the remote positive
(+) post of the discharged vehicle.
5. Reinstall the protective cover over the
remote positive (+) post of the discharged
vehicle.
If frequent jump starting is required to start your
vehicle you should have the battery and
charging system tested at an authorized dealer.
CAUTION!
Accessories plugged into the vehicle power
outlets draw power from the vehicle's battery,
even when not in use (i.e., cellular devices,
etc.). Eventually, if plugged in long enough
without engine operation, the vehicle's bat-
tery will discharge sufficiently to degrade bat-
tery life and/or prevent the engine from
starting.
REFUELING IN EMERGENCY – IF EQUIPPED
The vehicle is equipped with a refueling funnel
for a Cap-Less Fuel System. If refueling is
necessary, while using an approved gas can,
insert the refueling funnel into the filler neck
opening. Take care to open both flappers with
the funnel to avoid spills
IN CASE OF EMERGENCY
NOTE:
Vehicles with diesel engines will have a cap to
remove to begin the refueling process.
Diesel Fuel Cap
NOTE:
In certain cold conditions, ice may prevent the
fuel door from opening. If this occurs, lightly
push on the fuel door to break the ice buildup
and re-release the fuel door using the inside
release button. Do not pry on the door.
375
7