Parkview Rear Back Up Camera - Jeep Gladiator 2021 Owner's Manual

WARNING!
Drivers must be careful when backing up

even when using ParkSense. Always check
carefully behind your vehicle, look behind
you, and be sure to check for pedestrians,
animals, other vehicles, obstructions, and
blind spots before backing up. You are
responsible for safety and must continue to
pay attention to your surroundings. Failure
to do so can result in serious injury or
death.
Before using ParkSense, it is strongly

recommended that the ball mount and
hitch ball assembly be disconnected from
the vehicle when the vehicle is not used for
towing. Failure to do so can result in injury
or damage to vehicles or obstacles
because the hitch ball will be much closer
to the obstacle than the rear fascia/
bumper when the vehicle sounds the
continuous tone. Also, the sensors could
detect the ball mount and hitch ball
assembly, depending on its size and shape,
giving a false indication that an obstacle is
behind the vehicle.
CAUTION!
ParkSense is only a parking aid and it is

unable to recognize every obstacle,
including small obstacles. Parking curbs
might be temporarily detected or not
detected at all. Obstacles located above or
below the sensors will not be detected
when they are in close proximity.
The vehicle must be driven slowly when

using ParkSense in order to be able to stop
in time when an obstacle is detected. It is
recommended that the driver looks over
his/her shoulder when using ParkSense.

PARKVIEW REAR BACK UP CAMERA

The ParkView Rear Back Up Camera allows you
to see an on-screen image of the rear
surroundings of your vehicle whenever the gear
selector is in REVERSE. The image will be
displayed in the touchscreen display along with
a caution note to "check entire surroundings"
across the top of the screen. After five seconds
this note will disappear. The ParkView camera is
located on the tailgate, above the vehicle
license plate.
STARTING AND OPERATING
NOTE:
Removing the tailgate will disable the rearview
camera function.
Manual Activation Of The Rear View Camera
1. Go to the Controls screen by pressing the
"Controls" button located on the bottom of
the Uconnect display, and then press
"Backup Camera".
2. Press the "Back up Camera" button to turn
the Rear View Camera system on.
NOTE:
For vehicles equipped with the Uconnect 3 With
5-Inch Display, there is only one option for
manual activation of the Rear View Camera.
Press the "More" hard button on the Uconnect
system, and then press "Back up Camera".
When the vehicle is shifted out of REVERSE
(with Camera delay turned off), the rear Camera
mode is exited and the previous screen appears
again.
When the vehicle is shifted out of REVERSE
(with Camera delay turned on), the rear Camera
image will be displayed for up to 10 seconds
unless the vehicle speed exceeds 8 mph
(13 km/h), the transmission is shifted into
193
4