Powering The Camera - FLIR Ariel CM-3304 Series User And Installation Manual

Installing and Connecting the Camera
6. Loosen the tilt lock screws, adjust the tilting position in a range of 65 degrees, and tighten the tilt
lock screws. Rotate the black liner to adjust the panning position in a range of 360 degrees until
getting the desired surveillance angle.
Tip: Adjust the panning position and tilting position to get the desired surveillance angle.
7. Reinstall the lower dome and tighten the screws.
4.4

Powering the Camera

The camera is powered by an 802.3af PoE (Class 3) connection over the unit's network cable.
Caution:
1. This product must be connected only to a PoE network.
2. The PoE supply's rated output is 48VDC, 0.2A.
3. If the camera is installed for outdoor use, the PoE supply must be installed with proper
weatherproofing.
4. As a Listed Power Unit, the PoE should be marked as "LPS" or "Limited Power Source".
5. This product shall be installed by a qualified service person. Installation shall conform to all local
codes.
Attention:
6. Ce produit doit être connecté uniquement à un réseau PoE.
7. La puissance nominale de l'alimentation PoE est 48VDC, 0.2A.
8. Si la caméra est installée pour une utilisation extérieure, l'alimentation PoE doit être installé
avec l'étanchéisation appropriée.
9. Comme une unité d'alimentation «Listed», le PoE doit être marqué comme «LPS» ou «Limited
Power Source".
16
Figure 12: Power Connection
CM-3304/CM-3308 User and Installation Guide
March 10, 2019