FLIR Ariel CM-3304 Series User And Installation Manual page 51

2. Click View to view current network settings. The Internet Explorer Basic Settings dialog box
opens, displaying network interface information, including Ethernet connection speed, Ethernet NIC
MAC address, unit IP address, multicast address, and subnet mask. In the case of an IPv6
connection, the IPv6 address and IPv6 DNS address also are displayed.
To configure IP settings
3. In the IP Settings section, configure the following settings
d. Mode – From the drop-down list, select one of the following:
?
Manual – Used for connecting to the network via a static IP address.
?
PPPoE – The camera can access the network via a DSL modem using the
Point-to-Point Protocol over Ethernet (PPPoE). When connecting via a
PPPoE connection, the IP Address field is disabled. After selecting this
mode, enter the User Name and Password for the PPPoE account.
?
DHCP – Used for connecting to the network via a DHCP server. In DHCP
mode, the IPv4 Address, IPv4 Subnet Mask , and IPv4 Default Gateway
fields are disabled.
e. IPv4 Address – The IP address is necessary for network identification. Enter the IPv4
address if you are using IPv4 to connect to the network in Manual mode. In PPPoE and
DHCP modes, the IPv4 address is assigned automatically.
f. IPv4 Subnet Mask – Used to determine if the destination is in the same subnet. The
default value is 255.255.255.0. Enter the IPv4 subnet mask address if you are using IPv4
to connect to the network in Manual mode. In PPPoE and DHCP modes, the IPv4 subnet
mask address is assigned automatically.
g. IPv4 Default Gateway – Used to forward frames to destinations in a different subnet. An
invalid gateway setting causes transmission to destinations in other subnets to fail. Enter
the IPv4 default gateway address if you are using IPv4 to connect to the network in Manual
mode. In PPPoE and DHCP modes, the IPv4 default gateway address is assigned
automatically.
h. IPv6 Enable – If you are using IPv6, select the checkbox to enable IPv6.
i. Accept IPv6 Router Advertisement – If you are using IPv6, select ON. The default is OFF.
j. Enable DHCPv6 – If you are using IPv6, select ON. The default is OFF.
k. IPv6 Address – If you are using IPv6, enter the IPv6 address.
l. Subnet Prefix Length – If you are using IPv6, enter the subnet prefix length (1-128 digits).
m. IPv6 Default Router Address – If you are using IPv6, enter the IPv6 default router address.
March 10, 2019
Figure 52: Basic Settings Dialog Box
CM-3304/CM-3308 User and Installation Guide
Accessing the CM-330X via a Web Browser
45