Figure 15 Wireless Lan: General; Table 16 Wireless Lan: General - ZyXEL Communications Wireless-11g Access Point ZyXEL G-1000 v2 User Manual

4.4 Wireless LAN Screen
Note: If you are configuring the G-1000 v2 from a computer connected to the wireless
LAN and you change the G-1000 v2's SSID or WEP settings, you will lose your
wireless connection when you press Apply to confirm. You must then change
the wireless settings of your computer to match the G-1000 v2's new settings.
Click Network > Wireless LAN to open the General screen.

Figure 15 Wireless LAN: General

The following table describes the general wireless LAN labels in this screen.

Table 16 Wireless LAN: General

LABEL
Wireless Setup
Name(SSID)
Hide SSID
Channel
Selection
Security
Chapter 4 Wireless LAN
DESCRIPTION
(Service Set IDentity) The SSID identifies the Service Set with which a wireless
station is associated. Wireless stations associating to the access point (AP) must
have the same SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII
characters) for the wireless LAN.
Note: If you are configuring the G-1000 v2 from a computer
connected to the wireless LAN and you change the G-1000 v2's
SSID or WEP settings, you will lose your wireless connection
when you press Apply to confirm. You must then change the
wireless settings of your computer to match the G-1000 v2's
new settings.
Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box.
See the rest of this chapter for information on the other labels in this screen.
ZyXEL G-1000 v2 User's Guide
53