Configuring Wep Or Wpa(2) Psk Security; Table 9 Enter Name And Select Security - ZyXEL Communications Wireless-11g Access Point ZyXEL G-1000 v2 User Manual

The following table describes the labels in this screen.

Table 9 Enter Name and Select Security

LABEL
Wireless LAN Setup
Name(SSID)
Choose Channel ID
Security
Back
Next
Exit
Note: The wireless stations and G-1000 v2 must use the same SSID, channel ID and
WEP encryption key (if WEP is enabled) or WPA-PSK (if WPA-PSK is enabled)
for wireless communication.

3.3.2 Configuring WEP or WPA(2) PSK Security

Choose Basic (WEP) security to setup WEP Encryption parameters.
Chapter 3 Wizard Setup
DESCRIPTION
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the
wireless LAN.
If you change this field on the G-1000 v2, make sure all wireless stations use
the same SSID in order to access the network.
To manually set the G-1000 v2 to use a specific channel, select a channel from
the drop-down list box.
The level of Security can be selected as none, basic or extended. Choose
None security to have no wireless LAN security configured and proceed to the
"Apply Settings" on page 47 section.
Choose Basic (WEP) security if you want to configure WEP Encryption
parameters.
Choose Extend (WPA-PSK with customized key) or Extend (WPA2-PSK
with customized key) security to configure a Pre-Shared Key.
The next screen varies depending on which security level you select.
Click Back to return to the previous screen.
Click Next to continue.
Click Exit to quit the wizard without saving the changes.
ZyXEL G-1000 v2 User's Guide
43