Example Idsl Port Setup; User Authentication - ZyXEL Communications Prestige 1600 Configuration Manual

Prestige 1600 Universal Access Concentrator
Field
Authen(ticatio This field sets the authentication method for
n) Method incoming calls. You can choose Local or RADIUS.
The default for this field is Local. Please see the
next section on User Authentication for more details.
Protocol Press the [SPACE BAR], then [ENTER] to choose
from None, CHAP/PAP, CHAP or PAP. The default
is None.
User Name This will be used as the login name for local
authentication. You can enter a name with up to 31
characters. This will be N/A when you choose
RADIUS as your authentication method.
Password Enter the password for the remote user. This will be
N/A when you choose RADIUS as your
authentication method.
IP Address Refers to the IP address assigned to the CPE
Assigned to (Customer Premises Equipment), i.e., the client
Client device connected to the Prestige.
Start of Public Refers to the public IP address assigned to the
IP Address hosts behind the CPE. The IP range contains
contiguous IP addresses and this field specifies the
first one in the range.
IP Count In this field enter the number of addresses in the
public IP range. For example, if the starting address
is 202.x.x.1 and the IP count is 6, then the pool will
be from 202.x.x.1 to 202.x.x.6.
Multicast Turn on/off IGMP support IGMP-v2/IGMP-v1/None.
Please refer to the Multicast section earlier in this
manual for more details about this feature.
IP Policies You can apply up to four IP policy sets (from twelve)
by entering their numbers separated by commas,
e.g., 3, 4, 6, and 11.
6.1.1

Example IDSL Port Setup

In Menu 6.1, the Start of Public IP Address and IP Count fields are for public IP addresses only. If NAT is not
enabled, and the hosts behind the CPE have been assigned public IPs, then you must enter that information here to
enable proper routing.
6-4
Description Option
Local, RADIUS
None, CHAP, PAP, CHAP/PAP
IGMP-v1
IGMP-v2
None
DSL Port Setup