Ip Policies; Tcp/Ip Ethernet Setup; Figure 5-1 Menu 3.2 - Tcp/Ip Ethernet Setup; Table 5-2 Tcp/Ip Ethernet Setup Menu Fields - ZyXEL Communications Prestige 1600 Configuration Manual

Prestige 1600 Universal Access Concentrator
The Prestige supports both IGMP version 1 (IGMP-v1) and IGMP-v2. At start up, the Prestige queries all directly
connected networks to gather group membership. After that, the Prestige periodically updates this information by
sending a membership query to 224.0.0.1. IP Multicasting can be enabled/disabled on the Prestige LAN and/or
WAN interfaces using menus 3.2 (LAN) and 11.3 (WAN). Select None to disable IP Multicasting on these
interfaces.
5.3

IP Policies

Traditionally, routing is based on the destination address only and the router takes the shortest path to forward a
packet. IP Policy Routing (IPPR) provides a mechanism to override the default routing behavior and alter the
packet forwarding based on the policy defined by the network administrator. Policy-based routing is applied to
incoming packets on a per interface basis, prior to the normal routing. Create policies using SMT Menu 25 (see the
IP Policy Routing chapter) and apply them on the Prestige LAN and/or WAN interfaces using menus 3.2 (LAN)
and 11.3 (WAN).
5.4

TCP/IP Ethernet Setup

To edit Menu 3.2, select Menu 3 Ethernet Setup in the Main Menu and then the appropriate LAN. Then select the
submenu option 2, and press [ENTER]. The screen now displays Menu 3.2 - TCP/IP Ethernet Setup as shown
next.
Enter here to Confirm or ESC to Cancel:
Follow Table 5-2 to configure TCP/IP parameters for the Ethernet port.
Field
IP Address Enter the IP address of your Prestige 1600 in dotted decimal
IP Subnet
Mask
RIP
Direction
Version
Multicast
5-4
Menu 3.2 - TCP/IP Ethernet Setup
TCP/IP Setup:
IP Address= 192.168.1.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-2B
Multicast= IGMP-v2
IP Policies=
Network Address Translation= N/A
Address Mapping Set= N/A

Figure 5-1 Menu 3.2 - TCP/IP Ethernet Setup

Table 5-2 TCP/IP Ethernet Setup Menu Fields

notation.
Your Prestige 1600 automatically calculates the subnet mask
based on the IP address that you assign. Unless you are
implementing subnetting, use the value computed by the
Prestige 1600.
Press [SPACE BAR] to select the RIP direction among
Both/In Only/Out Only/None
Press [SPACE BAR] to select the RIP version among RIP-
1/RIP-2B/RIP-2M.
Turn on/off IGMP support and select the version from IGMP-
v2/IGMP-v1/None.
Description Example
192.168.1.1
255.255.255.0
Both
(default)
RIP-1
(default)
IGMP-v2
nternet Access
I