Applying An Ip Policy; Ethernet Ip Policies; Table 16-2 Ip Routing Policy - ZyXEL Communications Prestige 1600 Configuration Manual

Prestige 1600 Universal Access Concentrator
Field
Policy Set Name
Active
Criteria
IP Protocol
Type of Service
Packet Length
Len Comp
Precedence
Source:
addr start= / end=
port start= / end=
Destination:
addr start= / end=
port start= / end=
Action=
Gateway addr
Log
Type of Service
Precedence
16.3

Applying an IP Policy

This section shows you where to apply the IP Policies after you design them.

16.3.1 Ethernet IP Policies

From Menu 3 - Ethernet Setup, enter 2 to go to Menu 3.2 -TCP/IP Ethernet Setup.
16-4

Table 16-2 IP Routing Policy

This is the name of the policy set assigned in Menu 25 - IP Routing Policy
Setup.
Press the spacebar to select Yes to activate the policy.
IP layer 4 protocol, e.g., UDP, TCP, ICMP, etc.
Prioritize incoming network traffic by choosing from Don't Care/
Normal / Min Delay / Max Thruput / Max Reliability.
Enter the length of incoming packets (in bytes). The operators in the
Len Comp (next) apply to packets of this length.
Press the spacebar to choose from Equal / Not Equal / Less /
Greater / Less or Equal / Greater or Equal.
Precedence value of the incoming packet. Values range from 0 to 7
or Don't Care.
Source IP address range from start to end.
Source port number range from start to end; applicable only for
TCP/UDP.
Destination IP address range from start to end.
Destination port number range from start to end; applicable only for
TCP/UDP.
Specifies whether action should be taken on criteria Matched or Not
Matched.
Defines the outgoing gateway address. The gateway must be on the
same subnet as the Prestige if it's on the LAN, otherwise, the
gateway must be the IP address of a remote node. The default
gateway is specified as 0.0.0.0.
Press the spacebar to select Yes to make an entry in the system log
when a policy is executed.
Set the new TOS value of the outgoing packet. Choose from Prioritize
incoming network traffic by choosing from No Change / Normal / Min
Delay / Max Thruput / Max Reliability.
Set the new precedence value of the outgoing packet. Values range
from 0 to 7 or No Change.
Description
IP Policy Routing