Using Ftp Or Tftp To Restore Configuration; Restore Using Ftp Session Example; Ftp And Tftp Firmware And Configuration File Uploads; Figure 216 Restore Using Ftp Session Example - ZyXEL Communications P-2602H User Manual

Chapter 27 Tools

27.8 Using FTP or TFTP to Restore Configuration

This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your device
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE your device. When the Restore Configuration process is complete,
the device automatically restarts.

27.8.1 Restore Using FTP Session Example

Figure 216 Restore Using FTP Session Example

ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to Section 27.3 on page 346
over WAN.

27.9 FTP and TFTP Firmware and Configuration File Uploads

This section shows you how to upload firmware and configuration files.
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE your device.
FTP is the preferred method for uploading the firmware and configuration. To use this feature,
your computer must have an FTP client. The following sections give examples of how to
upload the firmware and the configuration files.
354
to read about configurations that disallow TFTP and FTP
P-2602H(W)(L)-DxA User's Guide