No Security; Table 33 Wireless Lan: General - ZyXEL Communications P-2602H User Manual

Chapter 9 Wireless LAN
The following table describes the labels in this screen.

Table 33 Wireless LAN: General

LABEL
Active Wireless
LAN
Network Name
(SSID)
Hide SSID
Channel
Selection
Security Mode
Apply
Cancel
Advanced
Setup

9.5.1 No Security

Select No Security to allow wireless stations to communicate with the access points without
any data encryption.
If you do not enable any wireless security on your ZyXEL Device, your network
is accessible to any wireless networking device that is within range.
122
DESCRIPTION
Click the check box to activate wireless LAN.
(Service Set IDentity) The SSID identifies the Service Set with which a wireless
station is associated. Wireless stations associating to the access point (AP) must
have the same SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII
characters) for the wireless LAN.
Note: If you are configuring the ZyXEL Device from a computer
connected to the wireless LAN and you change the ZyXEL
Device's SSID or WEP settings, you will lose your wireless
connection when you press Apply to confirm. You must then
change the wireless settings of your computer to match the
ZyXEL Device's new settings.
Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box.
See the following sections for more details about this field.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to reload the previous configuration for this screen.
Click Advanced Setup to display the Wireless Advanced Setup screen and edit
more details of your WLAN setup.
P-2602H(W)(L)-DxA User's Guide