Figure 26 Wireless Lan; Table 11 Wireless Lan Setup Wizard 2 - ZyXEL Communications P-2602H User Manual

3 Configure your wireless settings in this screen. Click Next.

Figure 26 Wireless LAN

The following table describes the labels in this screen.

Table 11 Wireless LAN Setup Wizard 2

LABEL
Network
Name(SSID)
Channel
Selection
Security
Back
Next
Exit
The wireless stations and ZyXEL Device must use the same SSID, channel ID
and WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is
enabled) for wireless communication.
4 This screen varies depending on the security mode you selected in the previous screen.
Fill in the field (if available) and click Next.
P-2602H(W)(L)-DxA User's Guide
DESCRIPTION
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
If you change this field on the ZyXEL Device, make sure all wireless stations use the
same SSID in order to access the network.
The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a
channel. Select a channel ID that is not already in use by a neighboring device.
Select Automatically assign a WPA key (only available if you enable OTIST) if
you want OTIST to configure a WPA key for you.
Select Manually assign a WPA-PSK key to configure a Pre-Shared Key (WPA-PSK).
Choose this option only if your wireless clients support WPA. See
page 68 for more information.
Select Manually assign a WEP key to configure a WEP Key. See
page 68 for more information.
Select Disable wireless security to have no wireless LAN security configured and
your network is accessible to any wireless networking device that is within range.
Click Back to display the previous screen.
Click Next to proceed to the next screen.
Click Exit to close the wizard screen without saving.
Chapter 3 Internet and Wireless Setup Wizard
Section 3.3.1 on
Section 3.3.2 on
67