Trunking Peer Call Screen; Table 68 Voip > Trunking > General - ZyXEL Communications P-2602H User Manual

Each field is described in the following table.
Table 68 VoIP > Trunking > General
LABEL
Enable Trunking
Auto Attendant
Timeout
Dialing
Interval(sec)
Enable Auto
Attendant
Authentication
Password
Apply
Cancel

12.6 Trunking Peer Call Screen

Use this screen to set up outgoing authentication accounts for forwarding calls through peer
devices (without proxy) and incoming authentication accounts for forwarding calls from peer
devices. To access this screen, click VoIP > Trunking > Peer Call.
P-2602H(W)(L)-DxA User's Guide
DESCRIPTION
Select this to turn on VoIP trunking on your ZyXEL Device.
This is the setting which determines how long the ZyXEL Device waits for a caller
to enter a phone number when it receives the call. Enter the number of seconds
before the Auto Attendant times out. The default value is 10 seconds and entering
0 does not change the default. Enter a value from 1 to 255 seconds.
When the auto attendant times out, the phone directly connected to the ZyXEL
Device rings.
Enter the number of seconds the ZyXEL Device should wait after you stop dialing
numbers before it makes the phone call. The value depends on how quickly you
dial phone numbers. The default value is 3 seconds and entering 0 does not
change the default. Enter a value from 1 to 255 seconds.
Select this to enable authentication for calls coming into your ZyXEL Device. This
is similar to enabling a PIN (Personal Identification Number) that callers must
enter to forward calls via your ZyXEL Device.
This is the PIN callers have to enter via their phone pad when dialing into your
ZyXEL Device to forward calls through it. Enter a number between 1 and 32 digits
long.
Click this to save your changes and to apply them to the ZyXEL Device.
Click this to reset the fields.
Chapter 12 VoIP Trunking
179