Dhcp Setup; Figure 57 Dhcp Setup; Table 28 Dhcp Setup - ZyXEL Communications P-2602H User Manual

Chapter 8 LAN Setup
Table 27 Advanced LAN Setup (continued)
LABEL
Allow between
LAN and WAN
Back
Apply
Cancel

8.5 DHCP Setup

Click Network > DHCP Setup to open this screen. Use this screen to configure the DNS
server information that the ZyXEL Device sends to the DHCP client devices on the LAN.

Figure 57 DHCP Setup

The following table describes the labels in this screen.

Table 28 DHCP Setup

LABEL
DHCP Setup
DHCP
112
DESCRIPTION
Select this check box to forward NetBIOS packets from the LAN to the WAN and
from the WAN to the LAN. If your firewall is enabled with the default policy set to
block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall
rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the WAN
and from the WAN to the LAN.
Click Back to return to the previous screen.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
If set to Server, your ZyXEL Device can assign IP addresses, an IP default
gateway and DNS servers to Windows 95, Windows NT and other systems that
support the DHCP client.
If set to None, the DHCP server will be disabled.
If set to Relay, the ZyXEL Device acts as a surrogate DHCP server and relays
DHCP requests and responses between the remote server and the clients.
Enter the IP address of the actual, remote DHCP server in the Remote DHCP
Server field in this case.
When DHCP is used, the following items need to be set:
P-2602H(W)(L)-DxA User's Guide