Wpa(2)-Psk; Figure 65 Wireless: Wpa(2)-Psk; Table 35 Wireless: Static Wep Encryption; Table 36 Wireless: Wpa(2)-Psk - ZyXEL Communications P-2602H User Manual

Chapter 9 Wireless LAN
The following table describes the wireless LAN security labels in this screen.

Table 35 Wireless: Static WEP Encryption

LABEL
Security Mode
Passphrase
WEP Key

9.5.3 WPA(2)-PSK

In order to configure and enable WPA(2)-PSK authentication; click Network > Wireless
LAN to display the General screen. Select WPA-PSK or WPA2-PSK from the Security
Mode list.

Figure 65 Wireless: WPA(2)-PSK

The following table describes the wireless LAN security labels in this screen.

Table 36 Wireless: WPA(2)-PSK

LABEL
Security Mode
WPA Compatible
124
DESCRIPTION
Choose Static WEP from the drop-down list box.
Enter a Passphrase (up to 32 printable characters) and clicking Generate. The
ZyXEL Device automatically generates a WEP key.
The WEP key is used to encrypt data. Both the ZyXEL Device and the wireless
stations must use the same WEP key for data transmission.
If you want to manually set the WEP key, enter any 5, 13 or 29 characters (ASCII
string) or 10, 26 or 58 hexadecimal characters ("0-9", "A-F") for a 64-bit, 128-bit or
256-bit WEP key respectively.
DESCRIPTION
Choose WPA-PSK or WPA2-PSK from the drop-down list box.
This field is only available for WPA2-PSK. Select this if you want the ZyXEL
Device to support WPA-PSK and WPA2-PSK simultaneously.
P-2602H(W)(L)-DxA User's Guide