Internet Access Setup; Figure 48 Internet Access Setup (Pppoe); Table 22 Internet Access Setup - ZyXEL Communications P-2602H User Manual

Chapter 7 WAN Setup

7.5 Internet Access Setup

Use this screen to change your ZyXEL Device's WAN remote node settings. Click Network >
WAN > Internet Access Setup. The screen differs by the encapsulation you select.
See Section 7.1 on page 93

Figure 48 Internet Access Setup (PPPoE)

The following table describes the labels in this screen.

Table 22 Internet Access Setup

LABEL
General
Mode
Encapsulation
User Name
Password
Service Name
98
for more information.
DESCRIPTION
Select Routing (default) from the drop-down list box if your ISP allows multiple
computers to share an Internet account. Otherwise select Bridge.
Select the method of encapsulation used by your ISP from the drop-down list
box. Choices vary depending on the mode you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET
ENCAP or PPPoE.
(PPPoA and PPPoE encapsulation only) Enter the user name exactly as your
ISP assigned. If assigned a name in the form user@domain where domain
identifies a service name, then enter both components exactly as given.
(PPPoA and PPPoE encapsulation only) Enter the password associated with the
user name above.
(PPPoE only) Type the name of your PPPoE service here.
P-2602H(W)(L)-DxA User's Guide