10.5 Configuring Port Forwarding
If you do not assign a Default Server IP address, the ZyXEL Device discards
all packets received for ports that are not specified here or in the remote
management setup.
Click Network > NAT > Port Forwarding to open the following screen. This screen is
available only when you select SUA only in the NAT > General screen.
See
Appendix F on page 417
Figure 81 Port Forwarding
The following table describes the fields in this screen.
Table 46 Port Forwarding
LABEL
Default Server
Setup
Default Server
Port Forwarding
Service Name
Server IP
Address
Add
#
Active
Service Name
Start Port
End Port
P-2602H(W)(L)-DxA User's Guide
Chapter 10 Network Address Translation (NAT) Screens
for port numbers commonly used for particular services.
DESCRIPTION
In addition to the servers for specified services, NAT supports a default server. A
default server receives packets from ports that are not specified in this screen. If
you do not assign a Default Server IP address, the ZyXEL Device discards all
packets received for ports that are not specified here or in the remote
management setup.
Select a service from the drop-down list box.
Enter the IP address of the server for the specified service.
Click this button to add a rule to the table below.
This is the rule index number (read-only).
Click this check box to enable the rule.
This is a service's name.
This is the first port number that identifies a service.
This is the last port number that identifies a service.
143