The Flash Key; Europe Type Supplementary Phone Services; Table 59 European Flash Key Commands - ZyXEL Communications P-2602H User Manual

• Three-Way Conference
• Internal Calls
• Call Park and Pickup
• Do not Disturb
To take full advantage of the supplementary phone services available through
the ZyXEL Device's phone ports, you may need to subscribe to the services
from your VoIP service provider.

11.11.1 The Flash Key

Flashing means to press the hook for a short period of time (a few hundred milliseconds)
before releasing it. On newer telephones, there should be a "flash" key (button) that generates
the signal electronically. If the flash key is not available, you can tap (press and immediately
release) the hook by hand to achieve the same effect. However, using the flash key is
preferred since the timing is much more precise. With manual tapping, if the duration is too
long, it may be interpreted as hanging up by the ZyXEL Device.
You can invoke all the supplementary services by using the flash key.

11.11.2 Europe Type Supplementary Phone Services

This section describes how to use supplementary phone services with the Europe Type Call
Service Mode. Commands for supplementary services are listed in the table below.
After pressing the flash key, if you do not issue the sub-command before the default sub-
command timeout (2 seconds) expires or issue an invalid sub-command, the current operation
will be aborted.

Table 59 European Flash Key Commands

COMMAND
Flash
Flash
Flash
Flash
Flash
Flash
11.11.2.1 European Call Hold
Call hold allows you to put a call (A) on hold by pressing the flash key.
P-2602H(W)(L)-DxA User's Guide
SUB-COMMAND DESCRIPTION
Put a current call on hold to place a second call.
Switch back to the call (if there is no second call).
0 Drop the call presently on hold or reject an incoming call which is
waiting for answer.
1 Disconnect the current phone connection and answer the
incoming call or resume with caller presently on hold.
2 1. Switch back and forth between two calls.
2. Put a current call on hold to answer an incoming call.
3. Separate the current three-way conference call into two
individual calls (one is on-line, the other is on hold).
3 Create three-way conference connection.
*98# Transfer the call to another phone.
Chapter 11 Voice
165